Hiding the filter board in back

I came to the conclusion to hide these in separate RF compartments (it didnt work as well as I thought it would) but its still this way. The filter board is in back, the brick in the middle and now the controller and Micro are in housings in the front, with filtering on all the leads. I used some Feed Thru caps and also those LC t devices. I have not powered it up again as the last time I was probing the controller RF hit it and opened the relays on back quick enough to pop 2 of the FETS and 2 stacks of 7.5 ohm 1w resistors. Its not bad I have spares I just don’t like letting the smoke out..

 

 feed thrus  filter LCtworking on the controller

0 Replies to “Hiding the filter board in back”

Leave a Reply

Your email address will not be published. Required fields are marked *